ET60 is a solid-state, low impedance, electronic voltage tester. It measures AC/DC voltages up to 600V. The ET60 does NOT require batteries; it is powered by the applied voltage. It is excellent choice for testing voltage in electrical circuits, at outlets, in light fixtures or anywhere else where AC/DC voltage testing is required.

• Features
• Voltage Tester for AC/DC voltage from 12-600V at nine useful levels aligned with commonly used voltages
• Uses standard replaceable multimeter test leads for versatility
• CAT IV 600V modern solid-state design for safety
• Easy to use bright LED display clearly reports the voltage present in the circuit being tested
• Integrated test-lead holders are used for lead storage or for holding the probes correctly spaced for insertion into tamper-resistant US-style outlets
• Inherent low input impedance reduces the possibility of falsely reading ghost or stray voltages on non-energized circuits
• Batteries not required, as tester is powered by the applied voltage in the circuit being tested
• No Batteries Required
• Warnings
• Before each use, verify tester operation by measuring a known voltage.
• Never use the tester on a circuit with voltages that exceed the category based rating of this meter.
• Do not use the tester or test leads if they appear to be damaged.

• Specifications
• Interchangeable Leads : Yes
• Included : Tester; Test Leads
• Frequency : 45Hz to 66Hz
• Drop Protection : 9.8' (3 m)
• Pollution Degree : 2
• Type : Solid-State, Low Impedance, Electronic Voltage Tester
• Standard : CAT IV 600V
• Display : LED
• Voltage : 12 to 600 V AC/DC
• Application : Test AC/DC Voltage From 12-600V
• Ingress Protection : IP54
• Overall Width (Inch) : 2.84
• Weight (oz) : 3.2
• Overall Height (Inch) : 1.44
• Overall Length (Inch) : 5.67
• Overall Width (cm) : 7.2
• Overall Height (cm) : 3.7
• Overall Length (cm) : 14.4
• Weight (g) : 91
• Height : 1.4400 in
• Width : 2.3500 in
• Depth : 5.6700 in
• Weight : 0.2000 lbs